Attachments are accessible only for community members.
Nov 10, 2015
12:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2015
12:23 PM
Using Windows7x64, the FX3 board is recognized when plugged into a USB3 card with a Renesas controller. The FX3 however appears as a 'Cypress FX3 USB StreamerExample Device'. If I rrun USB control center and attempt to download an image to the board I always get a message with 'Please reset you device to download firmware'. But it never enters what I'd expect to see as DFU mode?
A picture attached. Any help welcomed.
TAIA
Jerry.
1 Reply
Nov 10, 2015
12:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2015
12:36 PM
Fixed! Missing jumper on J4.