- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Psoc evaluation board LED2 is keep on blinking ,once it powered up.I am unable to debug and psoc creator not showing any target device.
help me with this issue..
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So you are talking about the green status LED. That indicates the Kitprog status and should light constantly. I would suggest you to
1st: Check versions. Creator 3.3 CP1, Programmer 3.23.1 KitProg (Check with Programmer) 2.12 (if not, update using programmer)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
When you tell us a bit more we might help you.
Which kit are you actually using: CY8CKIT-???
Which Creator version, latest is 3.3 and what OS, Widnows???
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi bob,i am using CY8CKIT-042-BLE and psoc creator 3.3.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No.....I am not working with that..and this is the link
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So you are talking about the green status LED. That indicates the Kitprog status and should light constantly. I would suggest you to
1st: Check versions. Creator 3.3 CP1, Programmer 3.23.1 KitProg (Check with Programmer) 2.12 (if not, update using programmer)
Bob