- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm using the CY8C21534 and have a few questions about the tuning process of the capsense CSD user module. Can someone help me with these?
- in the tuning process flowchart ( CY8C21x34/B CapSense® Design Guide page 32 ) it is stated that the SNR should be between 5 and 8. In all other documentation I only found that the minium is 5 with no maximum given. What is the problem if the SNR is higher then 8?
- in that same flowchart the Ref Value is set to 2. In what case should this value be changed to an higher value?
Thanks.
Danny
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Danny,
If the SNR is above 8 the sensor may be over sensitive and may trigger even if the finger is up a distance. Also it increases in power consumption. And varying the Ref Value changes the rawcount but generally Rb is changed to tune the rawcount.
Thanks,
Yuva.