- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to control a digital multiplexer based on input from a serial command. I can't figure out how to command the multiplexer selection through the software (main.c). How do I do that? What document should I be looking at to determine this?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In Creator a HW mux can be controlled thru use of a control register. Just place the
HW mux and Control register, and look at the datasheets, they contain the APIs to
control it thru simple C calls.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Many thanks. Looks like its working.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
at the moment I try to control the digital multiplexer with register, too. But I have problems to connect them together via wire like Dana. My errors: Multiple drivers on Signal and terminal mux with width 2 is connected to wire with width 1.
I think its not a big problem but sorry I cannot find my mistake!
Regards,
Flo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content