PSOC 4 quits operating when unplugged from MiniProg3? Anonymous Not applicable Dec 28, 2015 03:22 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Dec 28, 2015 03:22 PM I currently have the CY8CKIT-049 4xxx (http://www.cypress.com/documentation/development-kitsboards/psoc-4-cy8ckit-049-4xxx-prototyping-kits) and I'm using the MiniProg3 to program the device with the usb portion broken off. The problem that I'm having is while the debugger is plugged in, my code runs fine. But whenever the Miniprog is unplugged everything stops. How do i make the PSOC not dependent on the miniprog3? 0 Likes Reply Subscribe All forum topics Previous Topic Next Topic 2 Replies Re: PSOC 4 quits operating when unplugged from MiniProg3? Level 8 rola_264706 Level 8 Dec 28, 2015 04:24 PM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Dec 28, 2015 04:24 PM Do you have another voltage source for the board besides the mini prog? 0 Likes Reply Re: PSOC 4 quits operating when unplugged from MiniProg3? Anonymous Not applicable Dec 29, 2015 06:59 AM Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Report Inappropriate Content Dec 29, 2015 06:59 AM I do, i figured it out. It seems my power supply had a low limit for the current supply causing the PSOC to lose power as soon as miniprog was removed. 0 Likes Reply Post Reply Related ProductsN-Channel Power MOSFETs Gate driver ICs FM3 32-bit Arm® Cortex®-M3 microcontroller Radar sensors for IoT Motor control ICs Related ApplicationsWashing machine Refrigerator Smart speaker Residential aircon Vacuum cleaner
