Jan 01, 2016
11:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 01, 2016
11:47 PM
Hi, new guy here.
I was wondering if I could (re)use the KitProg connection to my PC as a diagnostics channel for debugging. I want to send debug messages from the board to the PC (terminal).
Using the CY8CKit-059 for the 5PL.
Labels
- Labels:
-
ispn:39618:1:0
-
l1:314:1:0
-
PSoC5LP
2 Replies
Jan 02, 2016
04:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 02, 2016
04:57 AM
Welcome in the forum, ObiWanJacobi 😉 (Jacob??)
The Kitprog has got an USB-UART bridge. On the PC-side you may use a terminal program as PuTTY and connect it to the emulated COM- port the Kitprog maintains. On the PSoC side you have to use an UART connected to P12_7 and P12_6.
Bob
Jan 02, 2016
06:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 02, 2016
06:15 AM
Ok, so I need to place a UART component and route the RX and TX to those pins - easy.
Thanx,
Marc 😉