Anonymous
Not applicable
Jan 09, 2016
03:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2016
03:58 AM
Hi.
How can I send byte, using ALU, from A0 register outside UDB, for example to wire it to LEDs? I was trying few things but no one of them worked.
Labels
- Labels:
-
PSoC 5LP
5 Replies
Jan 09, 2016
04:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2016
04:36 AM
Have a look into the Component Author Guide (Start->Cypress->PSoC Creator 3.3->Component Development Kit->)
In the chapter 6.4 Complete the .h file you find the names you need to use for the accessible registers of the UDB.
Bob
Jan 09, 2016
12:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2016
12:42 PM
Ok, thx. I didn't saw this earlier, but...
Is there any way to get these bits only in hardware way, using Datapath Outputs?
Jan 09, 2016
02:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2016
02:36 PM
Use verilog and specify the bits as output of the component might work, I'm not quite fit in UDB programming...
Bob
Anonymous
Not applicable
Jan 10, 2016
05:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 10, 2016
05:15 AM
Ok. I;m stupid 😜 I've found option in ALU Outputs named - Shift Out (Left), and this is what I needed 😉
Jan 10, 2016
07:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 10, 2016
07:31 AM
Great!
Happy Coding
Bob