- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am modifying an existing application and adding a Wavdac8 to the project. The wavdac8 is simply generating a 600Hz tone to be used as CW side tone (I hope there are couple amateur radio operators on this forum :)). When CW is generated by another section of the code, I would like to turn the side tone on and off with the CW generation. I could simply stop start the component but my gut feeling is that is not the correct method to do it. Is there another component that could be inserted between the Wavdac8 and the PSoC 5 pin that can basically act as an ON/OFF switch.
The PSoC 5 will be driving a simple external circuit that basically consists of a transistor to drive a speaker.
Regards,
Ron
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ron,
can you use "ClockEnable" component, inserted between input clock and WaveDAQ ("clk enable" terminal goes to external pin)?
P.S. I built a transceiver very-very long time ago, not sure if this qualifies me for radio amateur.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I will take a look at that. I also had a Doh! moment. I could simply use another GPIO to turn the interface transistor on and off.
Regards,
Ron