- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have a CY8CKIT-044 Pioneer kit with PSoC 4 CY8C4247AZI-M485 on board. In another PCB, I have the same PSoC 4 and I would like to program it using the CY8CKIT-044 SWD Programming pins test points.
In the Pioneer Kit Guide for the CY8CKIT-044, Appendix A.3.16, it is noted that I should remove the R51, R53 and R55 which are 0 ohm resistors connected to the PSoC on board programming pins.
Since I am to program the same PSoC chipset, is it ok not to remove the resistors? I will be testing the code both on the PSoC 4 on board and the PSoC 4 in my PCB.
Thanks,
Kat
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No way. The kitprog cannot be connected to two target chips at the same time.
But
A cheap and safer solution would be to get hands on a CY8CKIT-043, snapp off the Kitprog and use that for programming any PSoC. No need to tamper with your valuable pioneer kit.
Bob