Anonymous
Not applicable
Jan 20, 2016
04:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
04:57 AM
We like to implement SPI in slave mode , but our SPI communication is point to point and we not want uses a microcontroller pin to enable/disable pin,. How we can force by software configuration (or Creator) SPI slave always receives data?
thanks
microcontroller : CYBL10573-56LQXI
Labels
- Labels:
-
BLE
4 Replies
Jan 20, 2016
05:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
05:22 AM
Connect the slave SS pin internally to a logic 1?
Anonymous
Not applicable
Jan 20, 2016
05:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
05:36 AM
is SCB in PROC microcontroller , can't assign a logical value in a schematic.
Jan 20, 2016
05:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 20, 2016
05:56 AM
Get in contact with Cypress. At top of this page "Design Support - > Create a Support Case". Would be good for us, when you post Cypress's answer here.
Bob
Jan 21, 2016
01:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 21, 2016
01:15 PM
Short from pulling the actual pin low I cannot see that the SCB SPI allows that mode of operation.