- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good afternoon everyone,
I have here the Cy8Ckit-059 Psoc5LP and I think to design a filter EMG in this device.I know this is probably a silly question, but I'm encountering some difficulties to make this project.
If I'm right, I have to use a ADC, DMA, Digital Filter and VDAC blocks to make the Band-pass filter. The problem is that I do not know about using DMA block.
If you can tell me what I should know about it I will be very grateful.
Other tips that may help with my work will be of great help.
Thank you very much in advance,
Felipe Rodrigo Ribeiro Oliveira
Brasil/MG
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Felipe, Your question is very general and it's hard to give specific advice until you have a start on the project. But in addition to reading documentation, remember that PSoC Creator has a DMA Wizard to auto generate code that you can copy/paste into your program. The Wizard is under the Tools tab.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When viewing Creator Start Page there is an entry "Find Example Project". Here you may specify your PSoC5 and have a look at the filter examples.
Bob