Anonymous
Not applicable
Jan 27, 2016
05:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 27, 2016
05:14 AM
I would like to know if is possible to use only the BLE link layer disabling the host in the POcC 4 BLE
Labels
- Labels:
-
BLE
2 Replies
Anonymous
Not applicable
Jan 29, 2016
05:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 29, 2016
05:47 AM
Hi,
What do you actually mean by disabling the host? Do you mean the higher layers? If so which one?
Regards,
- Madhu Sudhan
Anonymous
Not applicable
Jan 29, 2016
06:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 29, 2016
06:30 AM
Hi,
I would like to use the device as a BLE controller, in this case I can send standard HCI commands. I saw that the device has HCI_Mode that does what I want. The next question is to know if all the standard commands are supported.
Regards,
Abelardo