- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Cypress,
In the documentation for the EZ-BLE PSoC Module (Document Number: 002-00023 Rev. *D Revised January 22, 2016) it says in table 4 on page 9 that pin 26 is a VREF (Reference Voltage Input).
However, in PSoC Creator (3.3 CP1) it says that pin 26 is n/c (Not Connected … I assume) when selecting the CYBLE-014008-00 device.
Who is right, the data sheet or PSoC Creator?
Kind regards
John Hansen
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update Creator to 3.3 SP1. Pin 26 is used by SAR as the external Vref
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update Creator to 3.3 SP1. Pin 26 is used by SAR as the external Vref
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks. I am surprised that PSoC Creator did not report that a new version was available.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Same happened to me, update manager did not inform me.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Bob. I saw the issue with pin 1.0 and 1.1 was also solved by this update. Are you a Cypress employee?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No, John,
I am not a Cypress employee. I am living in Germany near Bremen and I am a software engineer with 20-35 years of experience in digital hardware (and a little bit with analog hw). My first contact with PSoC1 showed me the versatility of the "Think PSoC" principle and so I have stayed with PSoC designs since.
Bob