- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
I am trying to create a program using the Psoc 5lp board. The exact board I am using is the CY8C5888LTI-LP097. I have been trying numerous examples of digital filtering. The first attempt I tried reading in an uint16 value from an ADC, sending that reading through a digital filtering equation that I derived myself. Next, I scaled that filtered 16 bit value to a uint8 value and used a WaveformDac to output the signal. This approach did not work as planned. After this I have tried the numerous examples using ADC to DMA to FILTER to VDAC and have failed each time.
If anybody has any suggestions I would appreciate hearing them. One thought is that this exact board is not capable of doing this.
Any thoughts or suggestions are appreciated.
-Cory
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
I have found my problem and everything is fixed! Thank You so much for your help over the past few days!
-Cory
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cory, you do not tell us which board you actually use. You name the chip, but you do not tell us which CY8CKIT-???? it is. Could be of some help, because some of the pins you're using might be occupied by a board specific function.
How are you equipped? Scope? Logic analyzer??
Please supply us with an actual project that you created, we'll have a look at. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob, my apologies. The board I'm using is CY8CKIT-059. Attached is my project as you asked for. I am testing by using a function generator with a DC offset of around 1 Volt and a 0.5Vpp sinewave at variable frequencies (to test filter). I use an o-scope to measure the input and output voltage waveforms. In this program I was using Pin_1 and "toggle" for debugging purposes.
Thanks
Cory
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cory, you used the WaveDAC component which is designed to generate pre-defined output forms, change the component to a VDAC.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob,
I have found my problem and everything is fixed! Thank You so much for your help over the past few days!
-Cory
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob:
I may be trying the same thing you are. By the way what was the problem you found that fixed your problem.
Thanks,
George.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi George.
This thread is 4 years old, so I would suggest you to start a new thread with exact description what you want and what doesn't run. Always helpful is to upload a project archive. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are always welcome, Cory!
Bob