- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I am very new to PSOC programming. I basically need to get voltage readings from an electric (voltage divider) circuit and transfer it to a PC over Bluetooth. Is it possible to do this using PSoC 4 BLE pioneer kit, or any other PSoC device? If so, then can someone please give me some guidelines on how I should proceed?
Thanks!
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In blue color are all external parts and connections. You find those in Creator Component Catalog under "Off Chip"-tab.The SW2 in your case is to be found on the CY8CKIT-042 BLE Pioneer kit. Have a look into the schematics.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In blue color are all external parts and connections. You find those in Creator Component Catalog under "Off Chip"-tab.The SW2 in your case is to be found on the CY8CKIT-042 BLE Pioneer kit. Have a look into the schematics.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks. It was the "Dedicated Interrupt" in the "Input" tab that I hadn't enabled and hence was not being able to connect the interrupt to the switch.