2 Replies Latest reply on Mar 3, 2016 1:31 AM by fama_1274276

    from debug to release with cy8kit-142 - CLCK

      Hi all,


      I programmed in debug mode for a project directly on a cy8ckit-142 with the miniprog 3. It was working fine, but with a lot of wires on it... Now, I put the cy8ckit-142 on a custom pcb but the clock seems to not work.


      In psoc creator, I selected ECO as main clock. In this selection, there are two capacitances to give. I looked in the cy8ckit schematic but there is no capacity connected with the crystal oscillator (24MHz)...


      Anyway, Is it the right clock selection? Because when I program with the miniprog3, power down, power up, nothing happens!


      Any suggestion?