Anonymous
Not applicable
Mar 02, 2016
05:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 02, 2016
05:57 AM
Hi all,
I programmed in debug mode for a project directly on a cy8ckit-142 with the miniprog 3. It was working fine, but with a lot of wires on it... Now, I put the cy8ckit-142 on a custom pcb but the clock seems to not work.
In psoc creator, I selected ECO as main clock. In this selection, there are two capacitances to give. I looked in the cy8ckit schematic but there is no capacity connected with the crystal oscillator (24MHz)...
Anyway, Is it the right clock selection? Because when I program with the miniprog3, power down, power up, nothing happens!
Any suggestion?
BR,
Herrmattoon
Labels
- Labels:
-
ispn:40038:1:0
-
l1:314:1:0
2 Replies
Mar 02, 2016
08:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 02, 2016
08:21 AM
The BLE examples start the ECO, but use the IMO as HFCLK.
Bob
Mar 03, 2016
01:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 03, 2016
01:31 AM
Thanks, I will take a look into one of these examles.