- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In datasheet on FX3 CYUSB301X/CYUSB201X (Rev. *R March 27, 2015) is specified that USB3.0 controller supplied in commercial and industrial temperature ranges. I need CYUSB3014-BZXI in 121pin BGA package and industrial temperature range. But the "Ordering Information" on page 45 in this datasheet shows me "GPIF II Data Bus Width" in 32 bit. I have limitation of 16 bit data width in my artix-7 FPGA design. I can't find any exact answer in that datasheet and on this forum for my answer. Can this controller (CYUSB3014-BZXI) works in 16 bit data width even in case with industrial temperature range?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You can use the part you are referring to in 16 -bit GPIF mode. The maximum GPIF data bus width that the part will support is 32 bits.
Regards
Dhritiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
Thank you. Information in datasheet on FX3 CYUSB301X/CYUSB201X on page 45 had put me in doubt.