- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To see the debug message, Trace menu is required.
When I installed Wiced IDE, "Trace" is not seen in menu bar.
How can I set this menu seen ?
Thank you.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WicedSmartDevice configuration is not seen even though I reinstalled IDE 2 times.
so I removed entire program(including registry) and folders and reinstalled.
then I could see "Trace" in the menu bar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Trace feature was not in SDK 1.x, but added in SDK 2.x with the release of the BCM20737 evaluation board.
Are you sure you're running the newer SDK ?
Are you able to see the Wiced Smart Device Configuration option as shown below?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WicedSmartDevice configuration is not seen even though I reinstalled IDE 2 times.
so I removed entire program(including registry) and folders and reinstalled.
then I could see "Trace" in the menu bar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's available within the Windows version of the IDE,