Attach an ez-BLE Module to CY8CKIT-059?

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I'm new to all that Cypress stuff. Sorry for having maybe stupid questions.

   

 

   

Is it possible to extend a CY8CKIT-059 with a ez-BLE module? There is a place on the PCB but will it function when soldered? Is there something more to do? Are there any working examples for this setup?

   

Thanks a lot!

   

Regards,

   

Manfred

0 Likes
1 Solution
lock attach
Attachments are accessible only for community members.
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

Manfred I am sending you the manual for the Ez-Ble part.

View solution in original post

0 Likes
3 Replies
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

Manfred: The CY8CKIT-059LP doesn't have any pads for the Ez-Ble module the pads are for the Mini Prog 3 programmer. the CY8CKIT-043 module does have pads for the Ez-Ble module. You could hook up a Ez-Ble externally if you wanted too. 

0 Likes
lock attach
Attachments are accessible only for community members.
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

Manfred I am sending you the manual for the Ez-Ble part.

0 Likes
RoBO_1287886
Level 4
Level 4
First solution authored 25 replies posted 10 replies posted

Your question is interesting.

   

Your goal is to add BLE for the PSoC 5LP of your CY8CKIT-059 board.
In this case can use a bridge BLE-I2C (or other serial link). There are a few example of BLE project for dedicated dev board.
By connecting the two development boards, your PSoC 5LP can communicate in BLE (via the bridge).

   

rob1

0 Likes