CY5670 USB Dongle

[Anonymous]

Hi all,

   

I need to test the CY5670 USB Dongle as a GATT Server with a bluetooth name, connect it and send e receive command from a UART serial port software terminal

   

If I start Putty or TeraTerm and set the parameters COM7, Baud rate 115200, Parity Even, Data Bit 8, Stop bit 1, I don't receive any response.

   

Are there commands documentated to send through COM port to set the bluetooth name, bluetooth discoverable, etc?

   

Are they Hayes like commands?

   

Could you help me?

   

Thanks

[Anonymous · Accepted solution]

CY5670 USB Dongle is shipped with a default firmware which is intended to work with CySmart PC App. Can you confirm if your requirement is HCI (Host Controller Interface) Mode Operation or use the Dongle as BLE-UART Bridge? (http://www.cypress.com/blog/100-projects-100-days/project-020-uart-ble-bridge)

[Anonymous]

Thank you BMAH.

   

Now I'm looking for documentation about if is it possible to send commands from the serial interface to the USB dongle; can I disconnect a remote smartphone connected, change the advertising name, assign a specific mac-address, etc?