Mar 24, 2016
06:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24, 2016
06:59 AM
Hi im designing an application to use capsense buttons with psoc5 cy8ckit-059. i have fabricated a simple capsense board with five 12mm dia copper footprints each connected with a 1 mega ohm resistor. i think this should be ideal for the low end design im trying as i read somewhere. planning to use port 1 pins 2,4,5,6,7 for my 5 capsense buttons. im also using the onboard cmod capacitor. please suggest me if what im doing is correct and also the way in which i have to configure my capsense module in psoc creator. thank you.
Labels
- Labels:
-
PSoC 5LP
3 Replies
Attachments are accessible only for community members.
Mar 24, 2016
08:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 24, 2016
08:26 AM
Mar 25, 2016
07:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 25, 2016
07:31 PM
Thank you bob. What is
your suggestion to design a capsense board using single layer pcb?
Jul 18, 2019
01:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 18, 2019
01:02 PM