Mar 28, 2016
07:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 28, 2016
07:53 AM
I have designed a 9 button cap sense board design on PSoC 3. However, I would like disable and enable each individual button based on product selected. For example, if the product requires only 3 buttons, then, I should be able to disable 6 buttons via firmware. I am trying to have single artifact for the firmware, so when the 3 button product is selected, other buttons are disabled. Is there a way I can disable individual buttons? Or Should I place them in high impedance mode without any side effects?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 3
1 Solution
Mar 29, 2016
04:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 29, 2016
04:14 AM
There is a CapSense_DisableSensor() API where you may do what you request.
Bob
2 Replies
Mar 29, 2016
04:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 29, 2016
04:14 AM
There is a CapSense_DisableSensor() API where you may do what you request.
Bob
Mar 31, 2016
12:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 31, 2016
12:04 PM
Thanks Bob!