Attachments are accessible only for community members.
Anonymous
Not applicable
Apr 04, 2016
02:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2016
02:10 PM
I have designed a 2 layer PCB for touch sense as per the directions given in the datasheet. Can someone verify the design and suggest any changes .I will be using a 2mm acrylic overlay on top of it. This PCB will connect to main board using a short 6x2 cable.
All the dimensions are in mm and the isolation between pads and ground is 1.8mm. I want to use the center larger pad for activating other pad scanning so in low power mode controller will be scanning only the center pad.
Labels
- Labels:
-
BLE
2 Replies
Anonymous
Not applicable
Apr 04, 2016
10:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 04, 2016
10:43 PM
Kindly create a technical support case with Cypress. Our Engineers will assist you to review the designs.
Anonymous
Not applicable
Apr 05, 2016
12:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 05, 2016
12:20 AM
I have created it