- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have the CY8CKIT-042-BLE Pioneer Kit. Originally, I had the 3.3 version, and the setup page for creating new projects was new and strange to me. Then I switched to 3.2, and there is still no such an option for the "PSoC 4 Design". What should I do? Go for lower version or 3.2 is okay but I just didn't see the option? The attached is the setup page I have. Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
I strongly suggest you to use Creator 3.3, do not be afraid of new improvements!
Select your hardware as shown in the picture
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
I strongly suggest you to use Creator 3.3, do not be afraid of new improvements!
Select your hardware as shown in the picture
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Note that most of these selections show only when the corresponding software from the kits page at cypress.com is installed.