miniprog3 is connected,but show unconfigured

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I plug miniprog3 into USB, 4 LEDs flash briefly. Windows8 Device Manager shows miniprog3 is connected. but  the device manager show it is unconfigured, any ideas? how to proceed?

   

this is very urgent for us, please be help.

0 Likes
1 Solution
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

2nd try:

   

Start Cypress programmer v 3.24 (latest version) and see if the miniprog3 is listed in the devices. If so, select it and check for updates available. Use the "Utilities" tab to update firmware. Unplug, count to 27, then replug miniprog3 and wait until drivers loaded from web.

   

 

   

Bob

View solution in original post

0 Likes
4 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

Welcome in the forum!

   

Did you give the miniprog3 the time to upload the needed drivers from internet (connection required)? It takes some minutes to complete.

   

 

   

Bob

0 Likes
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

2nd try:

   

Start Cypress programmer v 3.24 (latest version) and see if the miniprog3 is listed in the devices. If so, select it and check for updates available. Use the "Utilities" tab to update firmware. Unplug, count to 27, then replug miniprog3 and wait until drivers loaded from web.

   

 

   

Bob

0 Likes
Anonymous
Not applicable

it is workable, thank you so much!

0 Likes
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

You are always welcome!

   

 

   

Bob

0 Likes