- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I plug miniprog3 into USB, 4 LEDs flash briefly. Windows8 Device Manager shows miniprog3 is connected. but the device manager show it is unconfigured, any ideas? how to proceed?
this is very urgent for us, please be help.
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2nd try:
Start Cypress programmer v 3.24 (latest version) and see if the miniprog3 is listed in the devices. If so, select it and check for updates available. Use the "Utilities" tab to update firmware. Unplug, count to 27, then replug miniprog3 and wait until drivers loaded from web.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum!
Did you give the miniprog3 the time to upload the needed drivers from internet (connection required)? It takes some minutes to complete.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2nd try:
Start Cypress programmer v 3.24 (latest version) and see if the miniprog3 is listed in the devices. If so, select it and check for updates available. Use the "Utilities" tab to update firmware. Unplug, count to 27, then replug miniprog3 and wait until drivers loaded from web.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
it is workable, thank you so much!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are always welcome!
Bob