Anonymous
Not applicable
May 20, 2016
10:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 20, 2016
10:50 AM
My application will use a rechargeable battery. I will let it run down to 2V or so before I need to reject connections until it charges back up. I can continue advertising because that has some value and does not effect charging much.
My battery voltage is measured by an external microcontroller which can set a pin on the BLE IC or it can send a command via I2C.
How can I reject BLE connections during "run time"? Can I read the "no conection signal" via I2C and then disallow connections?
Thanks
Rich
Labels
- Labels:
-
BLE
1 Reply
Anonymous
Not applicable
May 20, 2016
01:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 20, 2016
01:48 PM
Perhaps use the on chip ADC to measure it's own supply voltage to reject connection attempts?