The MOSI pin of the spi interface is low after the spi  initializated.

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
waxi_1305956
Level 3
Level 3

Hi,

   

 I use the spi interface of the fx3,the MOSI pin of the spi interface is low after the spi initializated.I have connected a Pull up resistor to this pin.How can i do to set this pin is high when the spi interface initialization?

0 Likes
2 Replies
Anonymous
Not applicable

Hi,

   

No external pull ups are required on the MOSI and MISO pins.Did you try with our example firmware and observe the same results?

   

Regards,

   

- Madhu Sudhan

0 Likes

yes,the results are same,the MOSI pin is low in the idle state.

0 Likes