Anonymous
Not applicable
Dec 31, 2013
02:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 31, 2013
02:06 PM
I'm working with AN75779. I'd like to see the output from the various CyU3PDebugPrint() calls. I'm not seeing much at the uart pins. Is there some initialization I need to do? What baud, parity, databits, stopbits, etc... am I looking for?
--Adam
4 Replies
Anonymous
Not applicable
Dec 31, 2013
03:18 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 31, 2013
03:18 PM
CyU3PDebugPrint() works fine on my dev board, but not on my actual hardware. At this point I'm going to assume it is a hardware problem and move on.
Anonymous
Not applicable
Dec 31, 2013
04:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 31, 2013
04:14 PM
Ok, looks like the dev board uses GPIO 48/49 for TX/RX. My actual hardware has GPIO 55/56. It's not obvious to me what i need to do in the code to switch them.
--Adam
Anonymous
Not applicable
Dec 31, 2013
04:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 31, 2013
04:15 PM
(Oh 115200 8N1, for anyone else searching the forums for the serial info)
Attachments are accessible only for community members.
Anonymous
Not applicable
Nov 02, 2014
04:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 02, 2014
04:52 PM