- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi:
I want to use PWM block in Cy8C3236AXI-138. it is used for control a stepping motor.I can't find any API() for control the PWM output number.
is there this API() ?
thanks a lot.
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"control the PWM output number"
Mickey, please explain what you understand by "PWM output number", I do not have the lightest clue.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"control the PWM output number"
Mickey, please explain what you understand by "PWM output number", I do not have the lightest clue.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Pulling out my crystal ball: do you want to control the number of pulses the PWM outputs (having it stop after a certain number of steps)? The PWM itself cannot do that, but you can add a counter to the PWMs TC output. Then the counter can signal when the steps are reached and stop the PWM.