- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
The PSoC Creator is complaining that I cannot connect my analog GPIOs to both the DATA_SWITCHER multiplexer and the scanning comparator. See attached screen.
Error Message:
AMuxHW (Hardware Amux) only supports controlled analog connections to GPIOs. Please make sure all the controlled analog connections are connected to GPIOs.
I think the router is confused between the GPIOs and the inputs of the scanning comparator.
Is there any way to address this?
Thanks
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The two scanning components use the same underlying switch matrix and so cannot be used in that configuration. A way out could be using two comparators, see attached picture.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It would be much easier for us to test, when you provide us with a project archive. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content