- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I tried to use the ADC-DMA16 Bit Continouse Buffering Example AN61102 but I have encountered a warning message which cannot point to any location (as shown in attached screen capture). Any advices/debugging tips from anyone, please? Thanks in advance.
Note I am using device CY8C-3866-040
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the prompt response.
Another question I have is that I am using Putty to monitor the ADC value to be transferred to PC. I have added .inf into the project root directory with the correct VID and PID as shown in the device descriptor and update the USB driver on my PC with the desired COM port. And I have connected the ADC input pin to P6[5] to vary the analog signal but I am not getting anything on Putty. I have tried with Putty using "USBFS_UART01" example to send data to DKT and it works. I am not sure what I have not done to allow me to see the ADC value transferred to PC when I use "ADC-DMA16 Bit Continouse Buffering Example AN61102 ".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What Board are you using? Self made? Development board? Which one??
What programmer are you using? Kitprog? Miniprog3?
And: Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have made a typo in the subject of this topic.
I am using PSoC 3 Development Kit CY8CKIT-030, hence, this answer your question on which programmer I am using. Nonetheless, I am using the on-board programmer.
I have bundle the complete project as shown in the attached. Please note I am only using the continuous buffering example. I have create the cyre file to solve 8051 problem but still it cannot get the ADC data to display on my putty. Thank you in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your development board has got two USB interfaces. One is for programming and the other is the PSoC3 USB. Did you connect both USBs to your PC?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You should connect both USBs at the same time, that will help you to debug your code at the same time.
Bob