PSoC5-LP integration with FPGA (Lattice Semi) and Operating Frequency Extension in PSoC5-LP

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Respected Members,

(1) What would be the best way to initiate a communication between FPGA and PSoC5-LP.

Actually, I want to utilize the ADC and OP-AMPS in PSoC-5LP and send data output from these modules to FPGA for further manipulation.
Following are the two devices that I am using in my design.

   

http://www.cypress.com/documentation/development-kitsboards/cy8ckit-059-psoc-5lp-prototyping-kit-onb...

http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/LatticeXP2Brevia2DevelopmentKit.aspx
 

   

(2) Lastly, is there any way to extend the crystal of above-mentioned PSoC5-LP prototype kit? i.e. from 80 MHz to 150 MHz or any other higher frequency? 

0 Likes
3 Replies
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

1) You may use the SPI or the UART interface your Lattice board has got.

   

2) No way for a PSoC

   

 

   

Bob

0 Likes
Anonymous
Not applicable

Thanks for your prompt reply.

0 Likes
Bob_Marlowe
Level 10
Level 10
First like given 50 questions asked 10 questions asked

You are always welcome.

   

 

   

Bob

0 Likes