- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I have downloaded the sample code of USB host into the CYUSB3KIT-001 board. However, the voltage value of VBUS keeps zero.
Base on the schematic, VBUS is enabled by the USB_DRV_VBUS while USB_DRV_VBUS is determined by CTL4_LT. CTL4_LT is connected to the port A of TXC0101DBVR (U45) and USB_DRV_VBUS is connected to the port B as shown in the Figure1. I can get 3.3V in CTL4_LT but only around 2.7V in USB_DRV_VBUS. I think that is why the VBUS keeps zero. What confuses me is the port A voltage should less or equal to port B according to the datasheet, but it is on the contrary actually.
By the way, figure 2 shows the setting of my board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The The I/O CTL 4 (J100) line can turn the power (VBUS_IN) ON or OFF in the firmware. Can you please check if it is in expected state?
Regards,
- Madhu Sudhan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I did check. I already get 3.3v on CTL4 and the program works as expect when it enable the vbus.