[PSoC5 designer]PLC and two ADC using CY8CPLC20

[Anonymous]

Hi~ 

   

I am trying to develop the PLC system(CY8CPLC20) with two AD converter but there are not enough blank area (shown as white color) in PSoC Designer. How can I add more sets of AD converter ? (add white blank area)

[Bob_Marlowe · Accepted solution]

The powerline component PLT is dedicated to use the analog columns 0,1 and 3. This only leaves column 2 for other things. There is no way to "free" or "add" more analog blocks, because they are built in hardware inside the chip.

   

You may try to use an analog multiplexer to input different signals to your ADC, so converting under software control one signal after the other.

           

Bob

[Anonymous]

Thank you, It's was very helpful

[Bob_Marlowe]

You are always welcome.

       

Bob