Anonymous
Not applicable
Jul 26, 2016
11:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 26, 2016
11:08 AM
For the CAN controller in MB9BF506NABGL I want to use the same 11 bit id (NMT_NODE_GUARD_ID 1792 ) as TX and as a RX
In my case RX works until I send on the same id from MB9BF506NABGL (NMT_NODE_GUARD_ID 1792 ), then RX stops working for this id.
I seems like I'm overwriting the RX setup registers when I send on the same Id
How is best to set the CAN controller registers to get this working ?
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Aug 01, 2016
12:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2016
12:11 AM
CAN configuration register set-up is available with the following example:
1 Reply
Anonymous
Not applicable
Aug 01, 2016
12:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 01, 2016
12:11 AM
CAN configuration register set-up is available with the following example: