- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
I am using KITPROG-043 and I have a UART component that prints DEBUG messages on Pins P7.0 and P7.1. As I have detached the KITPROG from PSoC4 I need to use the Pins provided on J2 header.
When I connect external FTDI to P7.0 and P7.1 I am not getting any debug messages. Is there some settings required for this? Can anyone help me with setting up UART DEBUG port?
Thanks in advance.
Lovelesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your UART is not connected to P7_0 and P7_1 but tp p0_4 and P0_5. You may wire those pins to the Kitprog to get your output via USB. The external wiring to the Kitprog is always needed after snap-off.
Bob