- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
This is a bit of a one off, but I'm curious to know if someone has been successful with adapting (configuring) the Character LCD with I2C Interface component for use with a 1602 display module such as this (http://www.ebay.com/itm/Display-IIC-I2C-TWI-SP-I-Serial-Interface-1602-16X2-Character-Blue-LCD-Modul...
They are inexpensive and I plan to use them in a new amateur radio transceiver based on the PSoC 5.
If this is not the proper forum for this post, please convey an alternate forum.
Regards,
Ron
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The 1602 is a normal display and will work with the PSoC HD44780 Controller components . Here is a program that should work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, I will take a look.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have built the project but have a question. Where is the schematic component located so that I may place it on the top design?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This a library you add the library to your library location then open a new project and add the library to your project using dependencies and you are ready to select the component. There is a schematic in the PDF of the library.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is a parallel model picture and it shows how to wire the LCD module you will only have 2 digital wires but you will need the other lines.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, Now I see. Thank you. I added the dependencies to the project and the component is now available.
Thanks again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is now working. Thanks!