- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the input tolerance of the OVT pins P5.0 and P5.1 on CYBLE-012011-00?
I can't seem to find an exact value in any of the datasheets.
I would like to connect one of the OVT pins through a series resistor with adequate value to the voltage source (+5V) of a USB port in order to identify whether the device is connected to a USB port or not.
Thank you in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you. I have one more question.
I found the mentioning of the input tolerance of GPIO_OVT pins in the 'Hot Swap' section.
Does this mean that the pin must be 'Hot swap' enabled and mapped to any of the GPIO_OVT pins (P5.0 or P5.1) for it to be 6V tolerant? Just want to make sure.
Thanks again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer Pg:37 of the component datasheet.
A GPIO_OVT pin is used if any of the following parameters is set.
□ Hot Swap is set to true
□ Slew Rate is set to I2C FM+, or I2C HS
□ Drive Current is set to 10mA sink
Thanks,
Anjana