UART to Bridge help

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I am currently working with the UART to bridge example but need help being able to set and clear a pin to control the direction of my RS485 half duplex chip. Its not obvious where the correct place would be to do this. Has anybody done this before? Need to be able to raise the pin and then send out the complete message and then clear the pin.

   

Maybe there is a better example then the UART to bridge code?

   

 

   

Any help would be greatly appreciated. I am using the BLE dongle and pioneer kit with the red module plugged in but I don't think that matters. 

0 Likes
2 Replies
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

Here is some information on this issue.

   

   

0 Likes
rola_264706
Level 8
Level 8
50 likes received 25 likes received 10 likes received

Use UART Version 2.50 component.

0 Likes