- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi May,
What is the part number of the PSoC you are using?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have 2 problem with new PSoC Designer 5.3 and 5.4:
- I could not find ACDIN12 user module in CY8C24794 chip
- I have an old project, in this CY8C24794 and ADCINC12, CSD together in one configuration. I new PSoC Designer when I put one CSD than I can not put any ADC module.
Please help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The hardware resources of a CY8C24794 are rather restricted, so you might use with Designer 5.4 an ADCINCVR set to 12 bit resolution and a CSDADC with PRS8, PWM8 or VC2 clock source. Just some small changes...
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Even though Bob already answered your question, you should post in a PSoC1 forum next time... Your chances of getting the proper answer are better over there.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for help. I start to use new user modue CSDADC now.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use IE or Firefox for forum, Chrome has issues.
Regards, Dana.