- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I recently brought a new CY8CKIT-059 kit for my project. I tried to load sample codes in the kit using PSOC designer 5.4 and PSOC creator but in the target device its empty. When i connected for first time i was able to see the name of kit appear in target device in the designer. I didn't dump the code that time. I couldn't fine the reason for sudden change. If anyone faced similar issue or have solution please help me.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Perhaps you have recently updated the software for Kitprog.
If the LED (LED3) gently pulsing it is Mass Storage mode.
Press and hold the RST button (SW3) at Kitprog for 5 seconds to exit Mass Storage mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you bobgoar. it was the bootloader problem and after installing new one it works fine. Thank you pavleon.