- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
similar to the problem mentioned here (http://www.cypress.com/forum/psoc-4-architecture/cy8ckit-043-4m-series-more-8-analog-pins)
is mine...
I need about 13 analog inputs (11 single sides , one differntial), see attached project.
I build an application using the seq SAR_ADC an an AMuxHW. The project compiles without an error. The software is running.
On the terminal I can read the values, but they behave strange and are not meaningful.
All values via the mux are nearly the same and seem to depend on the voltage of P2.6/P2.7 (diff input).
I tried several combinations, like only one input of the SAR-ADC, but it seems to me that the AMuxHW is not working proberbly.
I even added an analog output (TAnalog). By switching the inputs, I expected a change on that signal - nothing..
Anyone, any ideas 😉
Is there a restriction of the analog system, using the SAR-ADC and more than 8 inputs ???
Greetings (from germany)
Alex
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Alexander,
The code is missing Opamp_1_Start() statement. Could you please check whether it is working after adding it ?
Regards,
VSRS