Anonymous
Not applicable
Oct 25, 2016
09:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2016
09:00 AM
I am attempting to configure the ADCSAR on my CYBLE022001-00 module to monitor battery voltage. I will need to run it in differential mode as my Vcc is slightly less than 3.30v, and I need to detect a battery voltage range from 4.20v to 2.5v.
Just looking for guidance on pin configuration and setup.
Solved! Go to Solution.
Labels
1 Solution
Attachments are accessible only for community members.
Oct 25, 2016
04:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2016
04:42 PM
Here is your program I added the Diff input. I am running PSOC Creator 4.0. I changed the device to your device. You will need to have a resistance divider to measure over 3.3 Volts.
2 Replies
Oct 25, 2016
10:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2016
10:29 AM
There is a sample program for battery voltage monitors. Select file open example and search for ble and battery test.
Attachments are accessible only for community members.
Oct 25, 2016
04:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2016
04:42 PM