Problems with Hardware Connection - PSoC 4 Pioneer Kit

[Anonymous]

Hi,

   

I'm starting with the Pioneer Kit and want to use an easy HW-Connection to link the switch (P0_7) with the input of a counter to count down 3 button presses to switch on the red LED (P3_4).

   

Unfortunately i get an error when i check the HW connection on the digital input pin with the Drive Mode "Resistive pull up".

   

This is the error message:

   

Pin 0: Use of drive modes which are not High Impedance with a hardware-routed input requires a port adapter, but the selected device does not have one.

   

Can somebody explain, which is the meaning of this message?

[Bob_Marlowe]

Too many possibilities, can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.

       

Bob

[Anonymous]

Hi Bob,

   

in the meantime i found the answer:

   

Described on page 37  in the Pins datasheet --> Some devices, such as PSoC 4000 series do not have Port Adapters and this limits some pin features.

   

In this case i have to use my CY8CKIT-042-BLE to test it again.