- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1/ I am using the Using the CY8CKIT-042 BLE board, with the CYBLE 212019-00 microcontroller.
2/ I’ve created a workspace with :-
The following 2 projects :-
BleFindme01, BLE_OTA_upgradeableStckExample_Launcher01and BLE_OTA_upgradeableStckExample_Stack01.
3/ When I build the project using PSoc Creator 3.3 ( with service pack 2) on a laptop using windows 10, there is no problem. I can upgrade over the air with CySmart 1.2 etc.
4/ When I copy the workspace to my PC ( windows 7) & use PSCoc Creator 4.0, the software does advertise & when I connect the Green LED goes off, correctly.
5/ With the Green LED on, I press SW2, which turn the RED LED on. However, my mobile phone APP sees the over the air update ‘message’, but CyCSmart does not.
I then press the reset button, the blue led flashes momentarily, the red led comes on .
My mobile phone again sees the update message, but CY Smart does not..
The only way that I can get the microcontroller to advertise ( green LED on) is to reprogram the device through Psoc.
6/ The version of CYSmart is 1.2.0.122 on both PSs.
7/ Where is the problem ?
- Labels:
-
BLE
-
ispn:39611:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would suggest you to get in contact with Cypress directly: At top of this page select "Design support -> Create a Support Case" and ask your question. You will be helped by a Cypress engineer.
Bob