Anonymous
Not applicable
Nov 10, 2016
08:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2016
08:47 AM
Hi!
We are trying to integrate the CCG3 (using the CY4531 kit) with an embedded controller (EC) so that we can interact with the PD-negotiation process. However, we can't find any documentation of the I2C interface or example on how to use the HPI interface. Are there any pointers for this?
Also, is there a guide for how to setup runtime debugging between PSoC Creator and the CY4531 kit? Should we use the SWD-port this and a MiniProg? Or can it be done using the USB port we use for uploading the firmware. Couldn't find any documentation around this.
Kind Regards
Christian
1 Reply
Anonymous
Not applicable
Nov 10, 2016
08:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 10, 2016
08:59 PM
Hi!
Only EZ_PD configuration utility and MiniProg3 can be completed on the development of CYPD3121?