- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi there,
I have a block diagram for PSOC5. Now, I want to transfer from PSOC5 to PSOC4. However, there are some errors which said incompatible for certain block. May I know how can I solved this? I am new with this PSOC software. Thank you very much.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum.
There are some components available for PSoC5 that cannot be used for PSoC4 as the filter and the delta sigma adc. Usually there are in the PSoC4 adequate replacements. Those you need to use and change the APIs accordingly.
When you post your complete project, we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum.
There are some components available for PSoC5 that cannot be used for PSoC4 as the filter and the delta sigma adc. Usually there are in the PSoC4 adequate replacements. Those you need to use and change the APIs accordingly.
When you post your complete project, we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bob,
Thank you for your prompt reply. Yup, I have problems with delta sigma adc, dma, op-amp and also pga..the PSOC5 block diagram was given to me so that I can applied it to the PSOC4.
Affiq
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your selected device has not got DMA. Usa a different PSoC4BLE
Replace the "not supported" components with existing ones. For the PGA you will need to use an opamp and some external resistors.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you Bob. But what do you mean by using different PSoC4BLE?
Affiq
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your chip has got Bluetooth Low Energy (BLE) capabilities. When you do not need them, use a different family.
Bob