- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I am using CY8CKIT-042_BLE(PSoC 4 BLE), and I am using Cap Sense Slider LED project to learn, I want to monitor BLE data (from Cy smart App to CY8CKIT-042_BLE device)on UART terminal. I have tried including UART(SCB mode) module in the schematic.
I have tried seeing the output on PC terminal program with baud rate of 115200, but the message is garbeled (I think there is some issue with the clock.) also there are some errors which are shown below.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey Thanks for the timely help!
I have changed the frequency to 48 Mhz and it is working properly for 115200 baud and buffer is set at 16.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I could only find your initial UART_PutString(). Increase PSoC clock to 48MHz for better precision or lower the baud rate to 9600bd, set UART to byte mode and increase Buffers to 16
I get no compile errors anymore
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey Thanks for the timely help!
I have changed the frequency to 48 Mhz and it is working properly for 115200 baud and buffer is set at 16.